Please note we are currently performing essential maintenance to our website over the next 24/48 hours which means online ordering is currently suspended. This technological transmorgification may only take a few hours but equally we never really trust anything related to technology so bear with us if it takes a little longer. We apologise for any inconvenience this may cause. If you are struggling online then please email us at sales@classichandtools.com or telephone +44 (0) 1473 784 983 during office hours and we will make sure we look after you.

Kirjes Inflatable Sanders & Abrasive Sleeves

The Kirjes Inflatable Sanders are pumped up through an air inlet in the drive shaft located in the bottom of each sander. The air valve design leaves the bottom flat without a clumsy protruding valve on the sanders. This patented solution made it possible to make superior cylindrical drum sanders as well as a unique rounded sander with a dome shape at the business end. This moulded rubber bulb constantly flexes and changes shape, making the sanders soft all the way to the edge.

With the choice of eight (8) grits from extra coarse to extra fine, Kirjes eliminates scratches and allows you to apply the sander's total width against the work piece or to use only the edge in all kinds of complex sanding. The sander actually becomes flat when pressed against a flat surface and round when pressed against a round surface i.e. the sanders conform to the underlying surface. Consequently the sanders should be filled with very little air. The dome sander, needs to be pumped slightly harder than the drum sanders.


Back to Top