Blue Spruce Optima Mortise Chisels - Curly MapleBlue Spruce Optima Mortise Chisels - Curly Maple
New
Blue Spruce Optima Mortise Chisels - Curly Maple
Blue Spruce Toolworks new Optima Chisels feature a lapped and polished back with a flatness measured in light bands (the same system used to measure silicon wafers). When you unbox your new Optima Chisels, they’re razor sharp and 100% ready to go to work. Each Optima Chisel is machined from A2 tool steel, then double-tempered and cryogenically treated. The tempering and cryo treatments result...
from £122.00 inc VAT
Narex Mortice Chisels - Set of 4Narex Mortice Chisels - Set of 4
Narex Mortice Chisels - Set of 4
Robust mortice chisels for chopping out joints and cutting mortices. Sides taper in height and length from tip to shoulder for sidewall clearance. Bulky handle made from hornbeam which is strong enough to withstand heavy blows with a mallet. Overall length 304mm. Available as a boxed set of 4 (4mm, 6mm, 10mm and 12mm).
£66.00 inc VAT

Robert Sorby Sash Mortice Chisel
Robert Sorby Sash Mortice Chisel
Used for light mortising work, boxwood/satinwood handle. A 2 degree taper prevents binding in the cut. Ideal for clearing out waste from mortices for tenons, locks and hinges. Can be used with a mallet. Overall Size:- 279mm Blade Length 159mm
from £54.00 inc VAT
Veritas PM-V11 Mortice ChiselsVeritas PM-V11 Mortice Chisels
Last Ones!
Veritas PM-V11 Mortice Chisels
These are substantial mortice chisels. The blades are more than 1/2" thick at the heel of the bevel and are a consistent width from tip to shoulder for accurate registration in a mortice. The chisel sides are slightly relieved to reduce sidewall friction and allow for minor cut corrections. Each has a 25° primary bevel to make deep cuts easier, with a 35° secondary bevel to give them...
from £125.00 inc VAT

Lie-Nielsen Mortice Chisels
Lie-Nielsen Mortice Chisels
Designed with cabinetmaking in mind, these well-balanced Mortise Chisels are ground with parallel sides and are thicker than they are wide to help keep them straight in the cut. Made of A2 Tool Steel, hardened to Rockwell 60-62, cryogenically treated and double tempered. Maine-harvested Hornbeam handles. Overall length is approximately 10.5". The bevel is ground sharp at 30º, but a higher secondary...
£132.00 inc VAT
Henry Taylor Registered Mortice ChiselHenry Taylor Registered Mortice Chisel
Henry Taylor Registered Mortice Chisel
Made in Sheffield, England for over 150 years. Blade about 5½" long. F23 - 1/4" (6mm) F24a - 3/8" (9mm) F24 - 1/2" (12mm) F25 - 3/4" (19mm) F26 - 1" (25mm)
from £28.50 inc VAT

Henry Taylor Registered Mortice Chisel Set of 5Henry Taylor Registered Mortice Chisel Set of 5
Henry Taylor Registered Mortice Chisel Set of 5
Made in Sheffield, England for over 150 years. Blade about 5½" long. F23 - 1/4" (6mm) F24a - 3/8" (9mm) F24 - 1/2" (12mm) F25 - 3/4" (19mm) F26 - 1" (25mm)
£150.00 inc VAT