Classic Hand Tools

View Cart
   HomeShowsVisit UsAbout UsShippingLinksContact Us
Like us on FacebookFollow us on TwitterRead our Blog
 
 
 
     
   
     

    Secure Online Shopping

   
 

Secure Online Shopping




Gorilla™ Wood Glue Ref: 620

New Gorilla™ Wood Glue, bonds stronger, faster for wood-to-wood applications. It's hard working and long lasting. The special formula was created for a variety of wood surfaces, is water-resistant, and has no dyes for a better looking bond line. Gorilla Wood Glue is a leader in strength, providing an unmatched confidence level for success.

It requires only 20-30 minutes of clamp time, and is fully cured in 24 hours. Use indoors or out– passes ANSI/HPVA Type II water resistance. Good for use on hardwoods, softwoods, and wood composites. Dries a natural colour – there are no added dyes. Say goodbye to the "orange after-glow" from yellow glues. Easy to use – it's a non-toxic, water-based, solvent free polyvinyl acetate (PVA). FDA approved for indirect food contact. Easy clean up with water.

Application - For best results, it is essential that the wood surfaces are prepared prior to application of glue. For laminating, the surfaces should be thickness planed smooth, leaving the board surface free from machine marks, tear out and snipes. Also, be careful to avoid burnishing and end snipes.

Just how much Gorilla™ Wood Glue to apply depends on many factors. In general, apply a generous amount of glue on one of the surfaces. On hard-to-glue woods, apply the glue on both surfaces. Rub together with the other surface to distribute the glue evenly on both surfaces. Enough glue should be applied so that a fine bead of glue squeeze-out will occur when clamping.

Coverage– 1 gallon of Gorilla Wood Glue will cover about 200 square feet. 1 fluid ounce will cover approximately 1.56 square feet.

Clamping - In general, apply enough pressure that will cause a fine bead of glue to squeeze-out when the proper pressure is applied.

* Clamping Time (amount of time pressure needs to remain applied) – 20-30 minutes for room temperature applications.

* Working Time (amount of time before joint can be handled without stress) – 3-4 hours.

* Cure Time (amount of time for glue to reach total bonding strength) – 24 hours.

Clean-Up -Gorilla Wood Glue is water-soluble until dry.

* Clean-up while glue is wet– Use a clean damp cloth to wipe off excess glue. Make as many passes as needed with the clean area of the cloth to remove all the glue. When areas have completely dried, sand as needed. Wash hands, skin and damp cloths in soap and warm water, then rinse.

* Clean-up when glue has dried– Use a sharp putty knife, razor, or sharp scraper to shave hardened glue from surface, then sand as needed. Soak hands and skin in soap and warm water, wash then rinse.

* Cleaning the glue bottle tip– Use a clean damp cloth to wipe off excess glue after closing. If tip becomes clogged with dry glue, remove the cap and push the clog backwards with a toothpick then rinse cap with warm water. 





Gorilla™ Wood Glue

Quantity:  


Gorilla Wood Glue 8oz (236ml) £5.48
Gorilla Wood Glue 18oz (532ml) £7.49



Original Gorilla Glue Ref: GGO-5000

Gorilla Glue bonds materials other adhesives simply can't--metal, stone, wood, ceramics, foam, glass and much more! And it's still the best glue for anyone who wants the job done right.

* VERSATILE – ideal for most household fixes, building repairs and creative projects.

* 100% WATERPROOF – does not break down when exposed to outdoor elements. Easily passes ANSI/HPVA HP-1-2000 Types 1 and 2.

* TEMPERATURE RESISTANT – once it’s dry Gorilla Glue is unaffected by extreme heat or cold.

* SANDABLE, PAINTABLE, STAINABLE – the invisible glue line makes finishing easy.

1. Prepare And Dampen The Surface

If you’re using Gorilla Glue for the first time, or binding a new type of material, we always recommend trying a test piece first. Prepare your surface: All surfaces must be clean, dust free and tight fitting. For shiny surfaces, such as metals, glass and some plastics, rough up the material to give the glue something to bite into. Damp it: Lightly dampen one surface with water. We recommend using a damp cloth or spraying with water. Do not saturate the surface. For dense hardwoods, lightly dampen both surfaces prior to gluing.

2. Evenly Apply Gorilla Glue Onto The Dry Surface

Glue It: Evenly apply Gorilla Glue onto the dry surface. Do not over apply. We recommend wearing gloves or applying with a disposable brush. If you do get the glue on your skin, try a dry cloth or paper towel first (particularly if the glue is still tacky). If that doesn’t work, try washing with soap and cold water, or using an exfoliator with a gritty texture. Dry your skin and apply lotion. We do not recommend any kind of alcohol or acetone. This actually strips the skin of its natural oils, which means the glue is more likely to stick.

3. Clamp The Two Surfaces Together Tightly

Clamp It: You must clamp the two surfaces together tightly. Make sure the clamping pressure is distributed evenly across the surface. Or, if you don’t have a clamp, use heavy objects to achieve the clamping pressure. For lighter objects, try using a rubber band to hold the pieces together tightly. Clamp objects for 1-2 hours for Gorilla Glue and just 30-60 minutes for Gorilla Glue fast curing formula. For best results, leave overnight.

Clean up: If you need to remove any uncured ‘squeeze out’ or wet glue, we recommend wiping with a dry cloth or using a standard paint thinner. Make sure you use the solvent with care in a well-ventilated area. Always wear gloves. Once the glue is dry, it is best removed mechanically: try sanding, chiseling, scraping or picking. The dried glue will not damage tools.

Storage: Squeeze the air from the bottle. Secure the cap tightly. Store in a cool dry place away from direct sunlight. Keep out of reach of children and animals

Prices include VAT 





Original Gorilla Glue

Quantity:  


Original Gorilla Glue 2oz (60ml) 50002 £5.89
Original Gorilla Glue 4oz (115ml) 50004 £8.59
Original Gorilla Glue 8oz (250ml) 50008 £13.00



Gorilla™ Super Glue Ref: GGO-780

Introducing new Gorilla™ Super Glue, the first super glue that keeps holding strong, even when the bond takes a hit--we call it our Impact-Tough™ Formula. Just hold in place for 30-60 seconds while the formula sets, no clamping necessary. It's what makes Gorilla™ Super Glue, so, well, super.

IMPACT STRENGTH– unique rubber particles increase impact-resistance and strength to handle everyday use after your repair or creation is set. WON'T CLOG – anti-clog tip with metal pin keeps nozzle clean. EASY TO USE – thick formula flows better for improved control. Dries in just 30-60 seconds, with no clamping. WHATEVER THE SURFACE– use on nearly anything, from wood, metal, ceramics, some plastics, rubber and a whole lot more!

How is Gorilla Super Glue different from Gorilla Glue? - Gorilla Super Glue is a cyanoacrylate adhesive. Gorilla Glue is a polyurethane adhesive. Gorilla Super Glue does not require extended clamping or moisture to activate. It does not foam during set up. In addition, Gorilla Super Glue is recommended primarily for indoor applications only. Gorilla Super Glue is ideal for smaller repairs that require an instant bond and projects where clamping is not needed.

How do I use it? - Gorilla Super Glue is easy to use. It dries in 15-30 seconds and no clamps are needed. Simply clean the surfaces of your project to rid of dirt, dust and grease. Apply a small amount of Gorilla Super Glue (more isn't always the better: use 1 drop per square inch). Then put your pieces together and hold for 15-30 seconds. You can handle your project lightly after 1-5 minutes. 24 hours required for complete cure.

Why are the 2 bottles only half full? - Each bottle of Gorilla Super Glue contains 15 grams of adhesive, though the bottle is only half full. For high performance and usability the adhesive needs to be protected from air. One way keep the air out of the adhesive is by packaging in thick plastic bottles. If the bottle was completely full at 15g, and still the optimal thickness, it would be too hard to squeeze.

Price incl VAT
 
Read more notes





Gorilla™ Super Glue

Quantity:  


Gorilla Super Glue x2 3g tubes £4.74
Gorilla Super Glue 15oz bottle £6.49



Gorilla Tape Ref: GT-600

Gorilla Tape is made to stick to rough, uneven, unforgiving surfaces like wood, stone, stucco, plaster, brick and more. We have used here at Classic Hand Tools for a variety of jobs and it is much stronger than ordinary duct tape.

* DOUBLE THICK ADHESIVE – fills up the gaps in rough, uneven surfaces for super strong bite.

* STRONG REINFORCED BACKING – the tight weave makes Gorilla Tape extra strong, but you can still rip it straight and easy.

* TOUGH ALL-WEATHER SHELL – for the toughest jobs in the toughest conditions.

Price incl VAT 





Gorilla Tape

Quantity:  


Gorilla Tape "The Handy Roll" 9m 61001 £2.50
Gorilla Tape 11m 60012 £5.99
Gorilla Tape 32m 60035 £10.99
Gorilla Tape "Tough & Wide Roll" 27m 60030 £16.49



Veritas Chair Doctor Glue Ref: VK990

Chair Doctor glue can penetrate narrow cracks in chairs. I used this on my kitchen chairs which had become decidely wobbly and they are able to withstand my sons rough treatment again - excellent.

If a chair has a loose rung, an injection of Chair Doctor Glue will first swell the rung & then bond it.

The low viscosity lets it soak into the end grain of wood, swell it & then freeze the wood in its swollen state as it cures.

A film of dry glue is left on the walls of the wood cells, preventing contraction.

Cleans with water.

CHAIR DOCTOR PRO: includes 4fl oz of glue, 1 syringe, 3 sizes of blunt-tip needles

2 fl oz bottle has integral needle

Prices include VAT 





Veritas Chair Doctor Glue

Quantity:  

Size
Veritas Chair Doctor Pro CDPro - VK9904 £9.65
Veritas Chair Doctor Glue 2 fl oz (57ml) bottle £7.90